Developing Electronics for Environments Where Established Solutions Reach Their Limits
Electronic components are increasingly needed in environments where high temperatures or radiation limit the use of conventional technologies. These include engines, exothermic industrial processes, geothermal energy, mineral exploration, and aerospace applications.
Reliable data storage is particularly challenging. For temperatures above approximately 250 °C, there are no suitable, established storage solutions available for the operating conditions in question. The research goal is therefore set significantly higher and addresses temperatures up to 600 °C.
Retaining Non-Volatile Data Under Extreme Conditions
One research focus is on ferroelectric nitrides for non-volatile memory applications. Ferroelectric materials exhibit an electrical polarization state that can be retained even after the applied voltage is removed. This property enables non-volatile data storage.
For extreme environments, this polarization state must remain stable and reliable even under high thermal loads and, where applicable, radiation exposure.
Recent research on wurtzite ferroelectric nitrides demonstrates the significant potential of this material class. For partially switched AlScN and AlScBN thin films, exceptionally long extrapolated data retention at 150 °C has been reported.
Accelerating the Evaluation of New Functional Materials
In parallel with memory research, there is a growing demand for high-performance piezoelectric thin films for microelectromechanical systems (MEMS).
New material compositions must be investigated in terms of their composition, crystal structure, substrate compatibility, and functional properties. Flexible process conditions and short iteration cycles are therefore essential for identifying and further developing suitable material systems at an early stage.
Integrating Functional Thin Films Directly into Microelectronics
Another key driver is the increasing integration of functional materials into existing semiconductor and MEMS processes.
The objective is to provide piezoelectric and ferroelectric functionalities through thin films that can be fabricated using suitable wafer processes and integrated into future device architectures.
Fraunhofer Institute for Silicon Technology